Can't find what you are looking for?
Toll Free: 866-333-0728, Live Chat or e-mail us!

WireCrafters DEA Approved Woven Wire Partitions

Providing WireCrafters Products for 30 years.

Free Shipping!

Drug Industry’s Special Needs
As stipulated by 21 CFR 1301.72 storage areas for Schedule III through V controlled substances require a high level of security. Such installations have the following notable features.

Doors must be self closing and self locking.
WireCrafters offers a number of standard and custom lock options to meet this requirement, as well a line of self closing doors with mechanical and powered operators.

Walls constructed of not less than No.10 steel fabric with openings not more than 2-1/2" across the square, mounted on steel posts, set no more than ten feet apart, with horizontal reinforcement. WireCrafters standard panels are maximum ten feet long, four or five feet tall, and are made of 2" x 1" opening 10 gauge steel wire. The frames of our panels satisfy the requirement for horizontal reinforcement every sixty inches.

Walls shall be mounted to posts at least one inch diameter, lagged to the floor. Standard posts are 2" square with base plates for floor anchoring welded to each. Lag bolts need to be pinned or brazed once installed.

Shall have a ceiling of same materials, or erected to reach the structural ceiling of the building. WireCrafters system uses the same panels in walls and ceilings. Furthermore, our system is so strong panels can be stacked between posts to reach most any building ceiling.

Panels mount flush to floor. A simple modification to the hole layout on our stock posts eliminates the sweep space allowing flush to floor mounting of the panels as required for this application. WireCrafters offers these features plus years of experience providing approved enclosures to the drug industry.

WireCrafters Style 840 Woven Wire Partitions MATERIAL SPECIFICATIONS

PANELS - Shall be 10gauge steel wire crimped and woven in to 2" x 1" opening rectangular mesh, securely welded into a frame of 1-1/4" x 1-1/4" x 1/8" steel angle factory punched with 7/8" x 7/16" slotted holes to accept 3/8"mounting hardware. Panels four to six feet wide shall have one 1/4" x 3/4" flat stiffener, wider panels receive two 1/4" x 3/4" stiffeners. All panels shall be fastened to posts with 3/8" x 3" plated bolts and nuts.

DOORS- Hinged shall be constructed of the same materials as the panels with two 1/4" x 3/4" horizontal stiffeners across the width, and two diagonal 1/4" x 3/4" stiffeners from center to the corner. Hinged doors shall be equipped with padlock lugs (cylinder lock optional), three 4" x 4" spun pin hinges, and pick plate/slam bar assembly.

DOORS - Sliding shall be constructed of the same materials as the panels with two 1/4" x 3/4" horizontal stiffeners across the width, and two vertical 1/4" x 3/4" stiffeners from center to top or bottom. Sliding doors shall be equipped with two 4 wheel trolley trucks, 1-7/8" x 2-3/8" door track, pad lock lugs (cylinder lock optional)and door keeper assembly.

POSTS - Shall be made of 2" x 2" x 14 gauge steel tubing. Base plates of 2" x 7" x 1/4" steel flat with two 7/16" round holes for anchoring, shall be welded to each tube. Posts are factory drilled with 1/2" holes to accept hardware for mounting panels.

HARDWARE - Shall be 3/8" standard thread grade two plated nuts and bolts. Floor anchors are 3/8" wedge type-provided.

FINISH - Non-plated parts receive one coat of gray acrylic enamel. Touch up paint included with each shipment.

Back