WireCrafters Woven Wire Pallet Rack Backing |
 |
Providing WireCrafters Products for 30 years. |
RackBack® panels bolt directly to your existing pallet rack
uprights creating a sturdy barrier between inventory and the
ground below. Durable all welded, angle frame panels give
constant protection from dangerous spills; protecting personnel
while containing inventory. Competitively priced with netting style
backing, easy to install, and stock items ready to ship in 48 hours
of your order, RackBack® is the system for you
Pallet Rack Backing.pdf
Installation Guide.pdf
Request for Quote
| Features: Standard sized panels 4' 0" or 5' 0" high, match beam length in width. Custom size panels available. Panels made of 2" x 2" x 10 gauge welded wire mesh. Flat steel stiffeners welded behind mesh for extra rigidity. Panels attach directly to rack with mounting brackets. Multiple attachment points (seven) on ends of each panel. Off set brackets allow for load to overhang rack beams. Stack panels one on top of the other to top of rack system. Above the Top" mounting allows panels to extend above top rack beam. Angle frame design gives installer clear access to hardware, speeding installation. Assembly hardware is inaccessible from the exterior of the partition. Standard 3/8" assembly hardware is the heaviest in the industry. System may be started at the floor or at any level where protection is required. Panels can be mounted to support posts-if stand alone system desired. Heavier options available. |
WireCrafters RackBack® MATERIAL SPECIFICATIONS |
PANELS - Shall be 10 gauge steel wire welded into 2" x 2" center to center square mesh, securely welded into a frame of 1-1/4" x 1-1/4" x 13 gauge steel angle factory punched with 7/8" x 7/16" slotted holes to accept 3/8" mounting hardware. Holes on vertical frame shall be punched on 6" centers. Panels six or seven feet wide shall have one 1/4" x 3/4" flat stiffener, wider panels receive two 1/4" x 3/4" stiffeners. Panels wider than ten feet shall be framed in 1-1/2" x 1-1/2" x 1/8" steel angle and receive three flat stiffeners. POSTS - (optional) Shall be made of 2" x 2" x 14 gauge steel tubing. Base plates of 2" x 7" x 1/4" steel flat with two 7/16" round holes for anchoring, shall be welded to each tube. Posts are factory drilled with 1/2" holes to accept hardware for mounting panels. HARDWARE - Shall be 3/8" standard thread grade two plated nuts and bolts. Floor anchors are 3/8" wedge type-provided. FINISH - Non-plated parts receive one coat of gray acrylic enamel. Touch up paint included with each shipment. |
| Back |
Material Handling Solutions Since 1978
|
Custom Equipment Company, Inc. Copyright © 2010. All rights reserved
|
 |
Become a Fan  |
 |