WireCrafters Pallet Rack Wire Backing

WireCrafters Pallet Rack Wire Backing

 

Back any rack with WireCrafters modular panel system. WireCrafters Rack Back panels bolt directly to your existing pallet rack uprights creating a sturdy barrier between inventory and the ground below. Durable all welded, angle frame panels give constant protection from dangerous spills; protecting personnel while containing inventory. Competitively priced with netting style backing, easy to install, and stock items ready to ship in 48 hours of your order. 

WireCrafters Pallet Rack Backing.pdf

    WireCrafters Wire Panel Safety Rack Backing

     

    Back any rack with modular panel system.  Rack Back Safety wire panels bolt directly to your existing pallet rack uprights creating a sturdy barrier between inventory and the ground below.  WireCrafters Wire Panel Rack Backing.
    WireCrafters Wire Rack Backing.pdf

    WireCrafters Pallet Rack Backing Features:
    • Standard sized panels 4' 0" or 5' 0" high, match beam length in width.
    • Custom size panels available.
    • Panels made of 2" x 2" x 10 gauge welded wire mesh.
    • Flat steel stiffeners welded behind mesh for extra rigidity.
    • Panels attach directly to rack with mounting brackets.
    • Multiple attachment points (seven) on ends of each panel.
    • Off set brackets allow for load to overhang rack beams.
    • Stack panels one on top of the other to top of rack system.
    • "Above the Top" mounting allows panels to extend above top rack beam.
    • Angle frame design gives installer clear access to hardware, speeding installation.
    • Assembly hardware is inaccessible from the exterior of the partition.
    • Standard 3/8" assembly hardware is the heaviest in the industry.
    • System may be started at the floor or at any level where protection is required.
    • Panels can be mounted to support posts-if stand alone system desired.
    • Heavier options available.

    WireCrafters RackBack® MATERIAL SPECIFICATIONS
    PANELS - Shall be 10 gauge steel wire welded into 2" x 2" center to center square mesh, securely welded into a frame of 1-1/4" x 1-1/4" x 13 gauge steel angle factory punched with 7/8" x 7/16" slotted holes to accept 3/8" mounting hardware. Holes on vertical frame shall be punched on 6" centers. Panels six or seven feet wide shall have one 1/4" x 3/4" flat stiffener, wider panels receive two 1/4" x 3/4" stiffeners. Panels wider than ten feet shall be framed in 1-1/2" x 1-1/2" x 1/8" steel angle and receive three flat stiffeners.
    POSTS - (optional) Shall be made of 2" x 2" x 14 gauge steel tubing. Base plates of 2" x 7" x 1/4" steel flat with two 7/16" round holes for anchoring, shall be welded to each tube. Posts are factory drilled with 1/2" holes to accept hardware for mounting panels.
    HARDWARE - Shall be 3/8" standard thread grade two plated nuts and bolts. Floor anchors are 3/8" wedge type-provided.
    FINISH - Non-plated parts receive one coat of gray acrylic enamel. Touch up paint included with each shipment.

    Send us your requirements for a fast quote:  [email protected]

    48 Hour Quick Ship: Stocked parts from warehouse.
    Five Day Fast Track: Stock parts with minor modifications.
    2-4 Weeks Shipment: Special and custom orders. 

    WireCrafters Wire Rack Backing Brochure
    WireCrafters Wire Rack Backing Brochure